Effect of Heat Treatment on the Microstructure and Wear Properties of Al–Zn–Mg–Cu/In-Situ Al–9Si–SiCp/Pure Al Composite by Powder Metallurgy

This study examined the effects of heat treatment on the microstructure and wear properties of Al–Zn–Mg–Cu/in-situ Al–9Si–SiCp/pure Al composites. Pure Al powder was used to increase densification but it resulted in heterogeneous precipitation as well as differences in hardness among the grains. Heat treatment was conducted to solve this problem. The heat treatment process consisted of three stages: solution treatment, quenching, and aging treatment. After the solution treatment, the main dissolved phases were η′(Mg 4 Zn 7 ), η(MgZn 2 ), and Al 2 Cu phase. An aging treatment was conducted over the temperature range, 100–240 °C, for various times. The GP zone and η′(Mg 4 Zn 7 ) phase precipitated at a low aging temperature of 100–160 °C, whereas the η(MgZn 2 ) phase precipitated at a high aging temperature of 200–240 °C. The hardness of the sample aged at 100–160 °C was higher than that aged at 200–240 °C. The wear test was conducted under various linear speeds with a load of 100 N. The aged composite showed a lower wear rate than that of the as-sintered composite under all conditions. As the linear speed was increased to 1.0 m/s, the predominant wear behavior changed from abrasive to adhesive wear in all composites.