Anti-infective DNase I coatings on polydopamine functionalized titanium surfaces by alternating current electrophoretic deposition

Implant-associated infections (IAIs) can cause serious problems due to the difficult-to-treat nature of the biofilms formed on the implant surface. In mature biofilms, the matrix, which consists of polysaccharides, proteins, lipids and extracellular DNA (eDNA), forms a protective environment for the residing bacteria, shielding them from antibiotics and host defenses. Recently, the indirect prevention of biofilm growth through the degradation of eDNA using an enzyme, such as deoxyribonuclease (DNase) I, has gained attention and is regarded as a promising strategy in the battle against IAIs. In this study, coatings of DNase I were applied on titanium implant materials and their anti-infective properties were investigated. First, the effectiveness of alternating current electrophoretic deposition (AC-EPD) as a novel processing route to apply DNase I on titanium was examined and compared with the commonly applied diffusion methodology (i.e. classic dipping). For the same processing time, the use of AC-EPD in combination with a polydopamine (PDA) coupling chemistry on the titanium electrode surface significantly increased the protein deposition yield as compared to classic dipping, thereby yielding homogeneous coatings with a thickness of 12.8 nm and an average surface roughness, Sa, of ∼20 nm. X-ray photoelectron spectroscopy confirmed the presence of peptide bonds on all DNase-coated substrates. Time-of-flight secondary ion mass spectrometry detected a more dense DNase I layer in the case of AC-EPD for electrodes coupled as anode during the high-amplitude half cycle of the AC signal. The enzyme activity, release kinetics, and shelf life of DNase I coatings were monitored in real-time using a quantitative qDNase assay. The activity of DNase I coatings produced using AC-EPD was three time higher than for coatings prepared by classic dipping. For both deposition methods, a high initial burst release was observed within the first 2 h, while some activity was still retained at the surface after 7 days. This can be explained by the stable attachment of a small fraction of DNase to the surface through covalent bonding to the PDA layer, while superimposing DNase deposits were only loosely bound and therefore released rapidly upon immersion in the medium. Interestingly, coatings prepared with AC-EPD exhibited a prolonged, gradual release of DNase activity. The AC-EPD DNase coatings significantly reduced biofilm formation of both Staphylococcus epidermidis and Pseudom