심부 화강암반의 수리특성 평가를 위한 현장수리시험 비교 및 해석 연구

In selecting a disposal site for high-level radioactive waste, the hydrogeological research of the site is very important, and the hydraulic conductivity and the storage coefficient are key parameters. In this study, the hydraulic conductivity obtained by two different types of field hydraulic test equipment and methods was compared and analyzed for the deep granite rockmass in the Wonju area to understand the hydraulic characteristics of the deep granite rockmass. One was to perform the lugeon test, constant pressure injection test, and slug test at a maximum depth of 602.0 m by using the auto pressure/flow injection system, and the calculated hydraulic conductivity ranged from 1.26E-9 to 4.16E-8 m/s. In the overall depth, the maximum and minimum differences of the hydraulic conductivity were found to be about 33 times, and in the same test section, the difference by test method or analysis method was 1.13 to 8.25 times. In the other, the hydraulic conductivity calculated by performing a constant pressure injection test and a pulse test at a maximum depth of 705.1 m using the deep borehole hydraulic testing system was found to be 1.60E-10 to 2.05E-8 m/s, and the maximum and minimum differences were found to be about 130 times. In the constant pressure injection test, the difference depending on the analysis method was found to be 1.02 to 2.8 times. The hydraulic conductivity calculated by the two test equipment and methods generally showed similar ranges as E-9 and E-8 m/s, and no clear trend was observed according to depth. It was found that the granite rockmass in the Wonju area where the field hydraulic test was conducted showed low or very low rockmass permeability, and although there are differences in the range of hydraulic conductivity and the depth of application that can be measured depending on the applied test equipment and test method, it is generally believed that reliable results were presented. 고준위방사성폐기물 처분부지 선정에 있어 부지의 수리지질학적 연구는 매우 중요하며, 수리전도도와 저류계수 등이 대표적 수리지질학적 인자이다. 본 연구는 원주지역 심부 화강암반을 대상으로 두 가지 다른 종류의 현장수리시험 장비와 방법으로 획득한 수리전도도를 비교 분석하여 심부 화강암반의 수리특성을 파악하였다. 하나는 지하수 관정 자동 주입 시스템 장비를 활용하여 최대 심도 602.0 m에 대해 루전시험, 정압주입시험, 슬러그시험을 수행하였고, 산정된 수리전도도는1.26E-9 ~ 4.16E-8 m/s의 범위를 보였다. 전체 심도에서 수리전도도의 최대와 최소 차이는 약 33배로 나타났고, 동일 시험 구간에서 시험 방법이나 해석방법에 의한 차이는 1.13 ~ 8.25배로 나타났다. 다른 하나는 대심도 수리특성 조사 시스템을 활용하여 최대 심도 705.1 m에 대해 정압주입시험, 펄스시험을 수행하여 산정된 수리전도도는 1.60E-10 ~ 2.05E-8 m/s으로 최대와 최소 차이는 약 130배 정도로 나타났다. 정압주입시험에서 해석방법에 따른 차이는 1.02 ~ 2.8 배로 나타났다. 두 시