Rate dependent deformation of carbon fibre reinforced Al-Li metal matrix composite

The dynamic deformation characteristics and failure behaviour of laminated carbon fibre reinforced Al-Li metal matrix composite has been studied experimentally with the objective of investigating the dependence of mechanical properties on the applied strain rate and fibre volume fraction. A vacuum melting/casting process was used for manufacturing the tested composite. Impact testing was performed using a Saginomiya 100 metal forming machine and a compressive split Hopkinson bar over a strain rate range of 10 -1 s -1 to 3×10 3 s -1 . It is shown that the flow stress of the composite increases with strain rate and fibre volume fraction. The highest elongation to fracture values were found at low rate loading conditions, although a significant increase in ductility is obtained in the dynamic range. The composite appears to exhibit a lower rate of work hardening during dynamic deformation. Strain rate sensitivity and activation volume are strongly dependent on strain rate and fibre volume fraction. Fractographic analysis using scanning electron microscopy reveals that there is a distinct difference in the morphologies of the fractures, with corresponding different damage mechanisms, between specimens tested at low and high strain rates. Both strain rate and fibre volume fraction are important in controlling fibre fragment length and the density of the Al-Li debris. The relationships between mechanical response and fracture characteristics are also discussed.