Frequency Response Properties of the B-Dot Sensors Employed on a High Current Pulsed Power Facility

B-dot sensor, as an important device, is extensively employed to measure the current flowing in the magnetically insulated transmission line (MITL). To shield the output signal of the B-dot sensor from electron flow and high electrical field in the MITL anode-cathode (A-K) gap and also avoid the electrical breakdown in the A-K gap, the sensor is often covered with the metallic film and located in a conductor cavity penetrating the MITL electrode hole simultaneously. The frequency response properties of such kind of sensor are investigated. The experiment results indicate that the upper limited response frequencies of the sensors with and without the attached 5-\mu m-thick Ni-Chrome foil are 50 MHz and 148 MHz, respectively. Moreover, as a result of penetration of magnetic flux into the cavity's wall and the wire loops wound to form the sensor, the low-frequency components of the B-dot sensor output signal are amplified, consequently the falling edge of the waveform given by the B-dot probe will be distorted. We have proposed a method to make a first-order correction for such effect by using a passive resistor-capacitor integrator instead of the numerical process suggested previously. The integrator combines the behaviors of integration and compensation of the B-dot sensor output. The actual measured current waveform can be directly obtained by multiplying the output signal of the integrator by the sensitivity of the B-dot monitor. The B-dot sensors and this post-processing method have been successfully used on a pulsed power accelerator.