Hydrophobization of chitosan films by surface grafting with fluorinated polymer brushes

[Display omitted] •Chitosan films were modified by “grafting from” polymerization followed by esterification reaction with a fluorinated compound.•Easy handling experimental conditions by ARGET ATRP were used.•Hydrophobic chitosan surfaces with low surface energy were obtained.•These water-resistant chitosan films could find applications in green packaging. Chitosan with its surface-properties and biodegradability is a promising biomaterial for green packaging applications. Till now, this application is still limited due to chitosan high sensitivity to water. Some existing studies deal with the incorporation of hydrophobic additives to enhance water-proof performances of chitosan films. As these additives may impair the film properties, our study focuses on chitosan efficient hydrophobization by means of simple and successful surface grafting reactions. Chitosan films prepared by solvent casting were modified by means of surface-initiated activators regenerated by electron transfer atom radical polymerization (SI-ARGET-ATRP) of 2-hydroxyethyl methacrylate (HEMA) followed by esterification reaction with fluorinated acyl compound. X-ray photoelectron spectroscopy (XPS), attenuated total reflection Fourier transform infrared spectroscopy (ATR-FTIR) and Time-of-Flight Secondary Ion Mass Spectroscopy (ToF-SIMS) highlighted the surface chemical changes after each step. Surface properties were investigated by contact angle measurements and surface energy calculations. Hydrophobic surfaces with low surface energy and good water-repellent properties were obtained using a simple handling polymerization procedure. This is the first study in applying ARGET ATRP to prepare hydrophobic biopolymer films offering potential applications in packaging.