Assessment of DC and low-frequency noise performances of triple-gate FinFETs at cryogenic temperatures
In this work an in-depth investigation in terms of short-channel effects, analog operation and low-frequency noise performances at very low temperature operation is given. The most important electrical parameters are investigated and it is highlighted that for our devices the downscaling to sub-10 n...
Gespeichert in:
Veröffentlicht in: | Semiconductor science and technology 2016-12, Vol.31 (12), p.124006 |
---|---|
Hauptverfasser: | , , , , |
Format: | Artikel |
Sprache: | eng |
Schlagworte: | |
Online-Zugang: | Volltext |
Tags: |
Tag hinzufügen
Keine Tags, Fügen Sie den ersten Tag hinzu!
|
Zusammenfassung: | In this work an in-depth investigation in terms of short-channel effects, analog operation and low-frequency noise performances at very low temperature operation is given. The most important electrical parameters are investigated and it is highlighted that for our devices the downscaling to sub-10 nm technologies leads to improved drain-induced barrier lowering (DIBL) and intrinsic voltage gain. As expected, cryogenic operation leads to an amelioration of the subthreshold slope and charge sharing effect. A reduction of the threshold voltage and of the effective mobility is also observed. Discontinuities in the subthreshold slope in the drain current-gate voltage characteristics can be linked to potential non-uniformities in the channel width. It was observed that noise spectra contain 1/f and generation-recombination contributions. Low-frequency noise measurements as a function of the applied gate voltage at cryogenic operation show that the carrier number fluctuations dominate the flicker noise in weak inversion. Access resistance noise contributions were evidenced in strong inversion. The fact that devices suffer from generation-recombination noise even at 10 K operation shows that there are some active traps even at this cryogenic temperature operation. The low-frequency noise measurements as a function of temperature (10 K-70 K) are used as a non-destructive device characterization tool in order to identify traps induced during the device processing and to make a correlation between the observed traps and some technological steps. |
---|---|
ISSN: | 0268-1242 1361-6641 |
DOI: | 10.1088/0268-1242/31/12/124006 |