Flint locking gun with rear charge mechanism Lars Blekberg, Jönköping ca 1750

Round, steel grooved barrel with eight-sided chamber, eight straight ribs. At the transition round-edge part a blackened ring. Guidance: Belt sight of steel with large, v-shaped screen. Pool grain of silver. Fortress: Two booklets. The barrel is attached with a screw from below from the hoop grip and a steel pipe pin. Rear charging mechanism in the form of an internal fluted steel cartridge, l: 41 mm, inserted from the back into the race, at the rear a round steel rod, l: 7 mm, fixed plate of the cartridge diameter. On the front of the plate a guide heel with locks on the underside. The cartridge is locked by a u-shaped steel heel on the underside of the sieve, which replays the steel rod on the cartridge, two guide screws for the locking plate screwed from the back into the barrel, in the barrel wall at the top of the groove for the cartridge’s guide heel. On the back of the guide plate a steel rod, which is attached by pin to a loose part of the piston neck, on the right side brass pin brass, on the underside steel springs with a lockcoat. For opening the mechanism, the sieve is pulled upwards and a button in front of the trigger is pressed. Flint locks of steel with a flat locking plate, wide bevelled edges, partially obliterated, engraved decoration, on both sides of the male a trophy group with cannons, oval shield mm. Engraved signature: “L. BLEKBERG.” S-shaped, flat male with bevelled edges, rank decor against punched background. Oval jaws, upper jaw loose, jaw screw with pear-shaped head. Donated Prison Boiler with Fals. Battery with a flat dungeon cap, bevelled edges, rigged fire steel with drip-shaped bevel at the top, simple, engraved decoration. Battery spring with bevelled edges, three-lobed spring leaf. On the inside of the locking pin a steel rod, the nerve attached to the rear locking screw. Attachment: Two locking screws. Curved trigger Contoured trigger plate. Whole of walnut in two parts, carved edge around the fittings and leaves at the pipnote, the piping and on the piston neck. Nose straps of horns, other fittings of steel. Piston coat with tab on the cob back, blade shaped closure, center strip with profiled edges, a screw. On the neck piece a tail screw blade with rounded end blade, not joined by the barrel. Broken, flat side plate with oval middle plate, stripe at the rear, partially obliterated, engraved details. A + a tubular, smooth tip. Ground with flat arms with bevelled edges, the front arm finished with urn with a tab blade