AIR CURTAIN SMOKING TABLE

A table with no preferential shape with seats. An absorber-like structure can be found on its upper part and these two are connected by a perforated case. The absorbing hole is in the middle of the case protected by a sieve-like plastic grid. The ventilator and the filter are built into the table. There is a double-layer hollow and flat cover of any size above the table, which is the absorber. From outside and above air is blown into the absorber, which is cooled down or warmed up as necessary, by the assistance of peltier elements, if required. There are downward blow slots at the brim of the absorber. The air blown out of these makes an air curtain, which must stop harmful materials from leaving the environment of the coffee table. A podium of any kind with a hollow interior is located under the table. The air shall be absorbed through the slots in the external or upper part or brim of the podium or slots in the seat backs. This air shall feed the absorber together with the air absorbed into the table and eventually cleaned. The ventilator inserted into the table shall absorb the smoke from the environment of the coffee table. From the absorber above the table an air curtain shall be blown out, a part of which shall move inside due to the sucking power of the table ventilator and another part shall be absorbed by the seat backs. The hot air around the lamp shall push the smoke down and it gets absorbed by the ventilator and the perforated case. The polluted air absorbed into the table and the podium shall move towards the absorber through a pipe through cleaning equipment to filter the air. The filters in the pipe or inside the table shall clean the air, which shall be then blown out of the absorber and the process may start again. On décrit une table sans forme préférentielle, assortie de sièges. Une structure de type absorbeur peut équiper sa partie supérieure, ces deux éléments étant reliés par un boîtier perforé. Le trou absorbant se trouve au milieu du boîtier protégé par une grille en plastique de type tamis. Le ventilateur et le filtre sont intégrés dans la table. L'absorbeur est constitué d'un couvercle à double-couche creux et plat, de dimension quelconque, placé au-dessus de la table. De l'air extérieur est aspiré par le dessus par l'absorbeur et refroidi ou réchauffé selon les besoins, si nécessaire à l'aide d'éléments à effet Peltier. Le bord de l'absorbeur comporte des fentes de soufflage orientées vers le bas. L'air soufflé hors de ces fent