LOOSENER WITH CONTROLLED HYDRAULIC DRIVE

Loosener with controlled hydraulic drive consists of a tank with hidroridynoyu, Hydraulic block filter relief valve controlled distributor, working body, the base of the machine. To the basic machine with digging equipment, consisting of gear control and working beams between which is pivotally mounted overhead traction frame and lower traction frame, between which is installed the hydraulic cylinder boom-lowering so that the body of his pivotally attached to the gear control at the point of fastening the lower traction frame and stem mounting points to the upper frame of traction to the working beam, which upright, with the possibility of movement along it established a working body, the bottom of which is fixed conical teeth of helical thread, which its back part is attached to the hydraulic motor output shaft. The reverse side of the housing which is attached to the cylinder rod that rigidly set in your body. Hydraulic motor and hydraulic cylinder connected to the hydraulic system of the machine base from which elevated pressure line and drain line, connected to the two-wire two-position distributor with manual control. Pressure line connected to the check valve is divided into two streams. Shtokovu cylinder cavity through a two-wire two-position managing distributor is connected to a drain line, which is connected to the main drainage pipeline hydraulic, hydraulic two-position and two-wire distributor. Two position two-wire manager rozpolilnyk is a building in which the bearings installed hydraulic motor drive shaft, which is rigidly connected to the valve, consisting of n balls, the angle between them can not be equal to 180 °. The internal cavity of the housing is a cylinder, which contains at least two intermediate cases, which are cylinders in mutually perpendicular cross-sectional radiuses are openings. Разрыхлитель с управляемым гидроприводом состоит из бака с гидрожидкостей, гидронасоса, блока фильтра, перепускного клапана, управляемого распределителя, рабочего органа, базовой машины. К базовой машины с рыхлительным оборудованием, состоящий из навески и рабочей балки, между которыми шарнирно установлены верхняя тяговая рама и нижняя тяговая рама, между которыми установлено гидроцилиндр подъема-опускания таким образом, что корпус его шарнирно прикреплен к навески, в точке крепления нижней тяговой рамы, а шток до точки крепления верхней тяговой рамы к рабочей балки, в которой вертикально, с возможностью передвижения вдоль нее установлены рабочий о