TOOTHBRUSH

PROBLEM TO BE SOLVED: To provide a toothbrush with which bristle tips are applied to a part to be desirably brushed and with which the touch is felt with a fingertip to make the finger movable.SOLUTION: In the center of the brush face of a brush base C, there is provided a rugged longitudinal stabilization hole in a non-bristle region which has no bristles implanted, which surrounds teeth, and which makes teeth easily inserted. In a frame surrounding the non-bristle region, the brush base C is provided in which bristles are implanted in a simple single ring. In the tip end flat face of the handle, a rugged projection 6 is provided, with a back opening 8 in the rear back of the handle, and with a flat face opening 7 on the flat face. A handle base D is prepared, with a slide tube 9 therein provided which connects the back opening 8 and the flat face opening 7 within the handle. With a longitudinal direction determined in which the brush base C is attachably/detachably set, there is installed from under the longitudinal stabilization hole the toothbrush which is fitted by pressing the rugged projection 6 of the handle base D. In the slide tube 9 of the toothbrush body, a ring strap is inserted to which a finger ring for fitting a finger is connected. In the tip end sticking out from the mouth, a ring larger than the mouth or a finger ring comparable to the foregoing is fitted for the purpose of preventing slipping out from the tube and then, a little finger, a third finger, a middle finger, etc., are put in the finger ring.SELECTED DRAWING: Figure 1 【課題】磨きたい箇所に毛先を当て、その感触を指先で感じ指を動かすことのできる歯ブラシの提供。【解決手段】ブラシ台Ｃのブラシ面中央部に毛束を植毛しない歯を囲み、歯を挟み易くする無毛域内に凹凸在る前後安定孔を設け、無毛域を囲む回りの枠に毛束をシンプルな１重リング植毛したブラシ台Ｃを設け、柄の先端部平面に凹凸突起６を設け、柄の後方背面に背面口８、平面に平面口７を設け、前記背面口８と平面口７を柄の中で繋ぐスライド管９を設けたハンドル台Ｄを設け、ブラシ台Ｃの着脱する前後方向を決め、前後安定孔の下から前記ハンドル台Ｄの凹凸突起６を与圧して嵌めて成る歯ブラシを設け、前記歯ブラシ本体のスライド管９に、指が嵌る指リングを繋いだリングストラップを挿入し、口から出した先に管から抜けないように口よりも大きいリングか前記と同等の指リングを嵌め、指リングに小指、薬指、中指等を嵌める。【選択図】図１