HERSTELLUNGSVERFAHREN EINES PRODUKTES AUS ALUMINIUM-MAGNESIUM-LITHIUM-LEGIERUNG

Method for manufacturing of an aluminium-magnesium-lithium product, comprising the steps of subsequently: (a) providing an aluminium alloy consisting of (in weight %): Mg 3.0-6.0, Li 0.4-3.0, Zn up to 2.0, Mn up to 1.0, Ag up to 0.5, Fe up to 0.3, Si to 0.3, Cu up to 0.3, 0.02-0.5 selected from the group consisting of (Sc 0.010-0.40, Hf 0.010-0.25, Ti 0.010-0.25, V 0.010-0.30, Nd 0.010-0.20, Zr 0.020-0.25, Cr 0.020-0.25, Y 0.005-0.20, Be 0.0002-0.10), balance consisting essentially of aluminium and incidental elements and impurities; (b) casting the aluminium alloy into an ingot; (c) preheating the ingot; (d) hot rolling the preheated ingot to a hot worked intermediate product; (e) cold rolling the hot worked intermediate product to a rolled product in both the length and in the width direction with a total cold rolling reduction of at least 15%; (f) solution heat treating the cold rolled product in the temperature range of 465 to 565° C. for a soaking time in the range of 0.15 to 8 hours; (g) cooling the solution heat treated product from the solution heat treatment temperature to below 150° C. with a cooling rate of at least 0.2° C./sec; (h) ageing the cooled product to provide a sheet or thin plate product having a minimum yield strength of 260 MPa or more and a minimum tensile strength of 400 MPa or more in at least the L- and LT-direction, a minimum yield strength of 230 MPa or more and a minimum tensile strength of 380 MPa or more in the 45° to the L-direction, and further having a minimum T-L fracture toughness Kco of 80 MPa.{square root}m or more for 400 mm wide CCT-panels.