Datensammelsystem

1,102,331. Selective signalling. GENERAL PRECISION Inc. 3 Feb., 1965 [5 Feb., 1964], No. 4765/65. Heading G4H. [Also in Division G1] In a position digitizing system using two denominational gear-coupled shafts in which the position of each shaft is converted inductively, by cyclically moving a magnet past a coil mounted on the end of an arm attached to the shaft, into a differentially timed pulse which is then converted into a duration significant pulse, each duration significant pulse is digitized by counting relatively high frequency clock-pulses, and transitional carry errors in the higher denomination are avoided (a) by arranging that four clock-pulses correspond to a single increment in that denomination, e.g. to a foot, (b) by blocking the first two clock-pulses that would normally be counted, (c) by passing the remaining clock-pulses to a divide-by-four circuit and then to the counter, the remainder resulting from the division always being ignored, and (d) by entering, at the end of each digitizing cycle, a further 0, 1, 2 or 3 pulses into the divide-byfour .circuit in accordance with the count achieved in the lower denomination, whereby the count in the higher denominational counter may be selectively increased by unity. Thus by subtracting two pulses from the higher denominational pulse train before its division by four, the higher denominational count is prevented from becoming too high, providing the tolerances within the system are not too large, and the final count is corrected at the end of each digitizing cycle, by reference to the lower denominational count.