Numerical simulation as a tool for optimizing tool geometry for rubber pad forming process

To produce a new component there are a trial and error stage to obtain a part without defects, which strongly depends on operator's experience. At this stage, the experience of designer and manufacturers should give an important aid to reduce trials to realize the minimization of response time and cost with maximization of the product equality. Rubber pad forming highly improves the formability of the blank because the contact surfaces between the rigid die and the rubber pad is flexible. This method enables to produce sheet metal components with complex contour by relatively low cost because only one rigid die is required. However, in aerospace field, parts are produced in small sheet metal bending and small number of components. It means that it is not worthy for large investments in tools and process design. For these reasons, it is necessary to use FE simulation of manufacturing process during the conceptual design.