In vitro elution characteristics of gentamicin-impregnated Polymethylmethacrylate: premixed with a second powder vs. liquid Lyophilization

Antibiotic-loaded bone cement, or antibiotic-impregnated polymethylmethacrylate (PMMA), were developed to prevent and treat bone and joint infections. Gentamicin is an antibiotic that is commonly used in combination with PMMA; however, gentamicin powder is hard to obtain in many countries. This study aimed to evaluate the elution characteristics of gentamicin-impregnated PMMA made with lyophilized liquid gentamicin, compared with PMMA; which is made from commercial gentamicin powder. The experimental sample was divided into 2 groups: the gentamicin power group (PG-PMMA) and the lyophilized liquid gentamicin group (LG-PMMA). Ten cement spacers were prepared in each group. These were produced by mixing gentamicin powder, or lyophilized liquid gentamicin, with a powder polymer before adding the liquid monomer (2 g of gentamicin and 40 g of PMMA). The volume and surface area of the antibiotic-impregnated cement spacers were 50 cm and 110 cm , respectively. Each spacer was immersed in phosphate-buffered saline, which was changed daily under sterile conditions. The solutions were collected to measure the level of gentamicin using the enzyme multiplied immunoassay technique (EMIT), at days 1, 2, 3, 4, 5, 6, 7, 14, 21, 28, 35 and 42. The collections from both groups had high concentrations of gentamicin on day 1 (113.63 ± 23.42 mg/dL in LG-PMMA and 61.7 ±8.37 mg/dL in PG-PMMA), but experienced a continuous decrease over time. The PMMA spacers from both groups could release gentamicin for up to 6 weeks (3.28 ± 1.17 mg/dL in LG-PMMA and 1.21 ± 0.28 mg/dL in PG-PMMA). However, there were significantly higher levels of gentamicin concentrations in the LG-PMMA group compared to the PG-PMMA group at all time points (P