A novel virtual synchronous generator control scheme of DFIG-based wind turbine generators based on the rotor current-induced electromotive force

•Various approaches for forming the internal EMF in the VSG control of DFIG-based WTGs and their features are discussed.•A novel DFIG VSG control scheme utilizing the rotor current-induced EMF as the VSG internal EMF is proposed.•The static and dynamic characteristic of the proposed VSG control scheme is studied.•Considering the static/dynamic operating characteristic and the grid demand, recommended ranges for key parameters are given. This paper focuses on the research of virtual synchronous generator (VSG) control technology for the doubly-fed induction generator (DFIG)-based wind turbines. The key for DFIG VSG operation is to construct an internal electromotive force (EMF) with the virtual rotor motion characteristic in the stator. The existing control schemes use the rotor or mutual flux-induced EMF as the internal EMF. Since the flux corresponds to a composite magnetic field generated together by the stator and rotor current. Any variations in the stator current caused by external disturbances will reflect on the rotor current to keep the flux constant. The rotor overcurrent is inevitable under a large external disturbance, threatening the safety of the rotor-side converter (RSC). Moreover, the flux is immeasurable. The accurate flux control depends on flux observers, increasing the complexity; while the control without observers cannot ensure the effectiveness, leading to control failure. To address these problems, a novel DFIG VSG control scheme with the rotor current-induced EMF as the internal EMF is proposed in this paper. The internal EMF is corresponded to the single magnetic field generated only by the rotor current. This can lead to the following benefits: the rotor current will not vary with the stator current and can be limited under large external disturbances, ensuring the safety of the RSC; the rotor current can be directly measured without the need for extra observers, reducing the difficulty of control implementations; the underlying controlled vector is unified with the traditional grid-following DFIG, favoring the retrofit of the installed DFIGs. Compared to the existing schemes, this scheme has a larger equivalent internal impedance. An additional rotor current-terminal voltage magnitude droop control is added to effectively restrain the problems brought by this larger impedance. Simulation and analysis results demonstrate that the proposed DFIG VSG control scheme effectively addresses problems in the existing schemes. Moreover, th