Impact of Hardware Choice on Talonavicular Arthrodesis Non-Union Rate

Category: Midfoot/Forefoot; Ankle Arthritis; Hindfoot Introduction/Purpose: Talonavicular arthrodesis is a commonly performed procedure in orthopedic foot and ankle surgery, for conditions including osteoarthritis, instability, and others. The surgery is frequently performed as part of a double or triple arthrodesis. Multiple surgical constructs have been described, including screws, plate/screw constructs, and staple/screw constructs. Few studies exist that specifically focus on the talonavicular joint, and those that do are often limited by low patient volumes. Studies that do study non-union of the talonavicular joint do not offer comparative data on non-union rates between the different methods of fixation. The purpose of this study was to determine the rate of arthrodesis in talonavicular fusion surgery among different fixation techniques and determine if hardware has a significant effect on union rate. Methods: This study is a retrospective single institution, multi-surgeon study evaluating arthrodesis rates in the talonavicular joint. Adult patients undergoing primary talonavicular fusion (isolated or as part of double/triple arthrodesis) from 2015-2018 with a minimum of 3 month radiographic follow-up were studied. Patients undergoing revision talonavicular fusion or fusion as part of Charcot reconstruction were excluded. Patient radiographic and chart notes were reviewed to assess fixation type (single screw, 2-hole compression plate, screw + staple, or 4-hole plate), the status of the arthrodesis at >=3 months and any hardware complications or reoperations following the index procedure. Descriptive statistics were generated for standard patient demographics and co-morbidities. Non-union rates were calculated for the cohort as a whole and for each fixation technique utilized along with the frequency of hardware complications/removal. Univariate analysis was performed to determine risk factors for increased non-union rate, including patient demographics, co-morbidities, and fixation technique. Results: A total of 101 patients were included. Hardware included 69 single screws, 27 two-hole compression plates, and 4 screw + staple constructs. Four patients (3.96%) went on to develop a nonunion of the talonavicular joint, while 10 patients (9.9%) required a removal of hardware procedure following the initial arthrodesis. Of nonunion cases, 3 patients had single screw hardware while 1 had a two-hole plate. Removal of hardware was necessary in 5/69 patien