Investigation and optimization of machining parameters influence on surface roughness in turning AISI 4340 steel
This paper focuses on the experimental investigation of machining parameters such as cutting speed, feed rate and depth of cut influence over surface roughness parameters (Ra, Ry and Rt) during turning AISI 4340 steel. Further, in order to achieve smaller surface roughness parameter values, the mach...
Gespeichert in:
Veröffentlicht in: | FME transactions 2020, Vol.48 (2), p.383-390 |
---|---|
Hauptverfasser: | , , , |
Format: | Artikel |
Sprache: | eng |
Schlagworte: | |
Online-Zugang: | Volltext |
Tags: |
Tag hinzufügen
Keine Tags, Fügen Sie den ersten Tag hinzu!
|
Zusammenfassung: | This paper focuses on the experimental investigation of machining parameters such as cutting speed, feed rate and depth of cut influence over surface roughness parameters (Ra, Ry and Rt) during turning AISI 4340 steel. Further, in order to achieve smaller surface roughness parameter values, the machining parameters are optimized using Taguchi's technique Signal-to-Noise ratio (S/N ratio). Analysis of Variance (ANOVA) is performed to determine the most contributing factor that influences the surface roughness parameters. It is observed that the feed rate is the most significant factor contributing by 70.50%, depth of cut by 18.54% and cutting speed by 9.15%. From the optimum condition obtained, a confirmation experiment is performed and the results obtained shows that the surface roughness parameter values are reduced by 31.63% than the designed experimental values. |
---|---|
ISSN: | 1451-2092 2406-128X |
DOI: | 10.5937/fme2002383B |