Microstructure and Mechanical Properties of Laser Direct Energy Deposited Martensitic Stainless Steel 410

The aim of this work is to study the phase transformations, microstructures, and mechanical properties of martensitic stainless steel (MSS) 410 deposits produced by laser powder-directed energy deposition (LP-DED) additive manufacturing. The LP-DED MSS 410 deposits underwent post-heat treatment, which included austenitizing at 980 °C for 3 h, followed by different tempering treatments at the temperatures of 250, 600, and 750 °C for 5 h, respectively. The analyses of phase transformations and microstructural evolutions of LP-DED MSS 410 were carried out using X-ray diffraction, SEM-EDS, and EBSD. Vickers hardness and tensile strength properties were also measured to analyze the effects of the different tempering heat treatments. It revealed that the as-built MSS 410 has very fine lath martensite, high hardness of about 480 HV , and tensile strength of about 1280 MPa, but elongation was much lower than the post-heat-treated ones. Precipitations of chromium carbide (Cr C ) were most commonly observed at the grain boundaries and the entire matrix at the tempering temperatures of 600 °C and 750 °C. In general, the tensile strength decreased from 1381 MPa to 688 MPa as tempering temperatures increased to 750 °C from 250 °C. Additionally, as the tempering temperature increased, the chromium carbide and tempered martensite structures became coarser.