RF Test Article to Assess the Impact of Non-Hexavalent Chromium-Based Conversion Coatings on Electrical Assemblies

Conversion coatings are used to inhibit corrosion on aluminum structures while maintaining electrical conductivity. The most common type of conversion coatings in aerospace applications (MIL-DTL-5541 Type I), contain hexavalent chromium compounds as the corrosion-inhibiting additive. These Type I conversion coatings have a long pedigree and are highly effective in preventing corrosion; however, the hexavalent chromium compounds in these coatings are carcinogenic and water-soluble. Therefore, the use of these compounds is highly regulated in order to protect both workers and the public leading to high cost in both use and disposal. In addition to these regulations, use of these materials on new designs for DOD is prohibited by DFARS 48 CFR Parts 223 and 252, and is scheduled to be prohibited in Europe in September 2017 by REACH regulations. In response, new more environmentally friendly non-hexavalent chromium-based processes are becoming available. Coatings resulting from these types of processes are referred to as MIL-DTL-5541 Type II conversion coatings. The long term reliability and performance impacts resulting from the use of these coatings are not fully understood and there currently is an effort in the U. S. aerospace industry organized by NASA to fully define these impacts while hardware is still in the design stage. While significant work has been performed to define the corrosion performance of various Type II conversion coatings, there has been minimal work performed to quantify the impact a Type II conversion coating would have on RF electrical assemblies where plated printed wiring boards (PWBs) and aluminum structures come in intimate contact. The primary concern for these assemblies is that these junctions are inherently susceptible to galvanic corrosion; PWBs are clad with copper, which is highly cathodic while aluminum is highly anodic. In order to reduce the potential for galvanic corrosion, PWBs in DOD applications are typically plated with SnPb coating which is less cathodic than the copper. In addition, an immersion bath is used to coat the aluminum with a conversion coating that is less anodic. Changes to the conversion coating could increase the galvanic corrosion occurring at this junction. In addition, RF signals may also be negatively impacted by changes to the electrical resistivity and parasitic capacitances caused by changes to this junction. For this reason, it is highly desirable to create a RF test article that is highly sen