Influence of anodization time on the surface modifications on α-Fe 2 O 3 photoanode upon anodization

In searching for a suitable semiconductor material for hydrogen production via photoelectrochemical water splitting, α-Fe 2 O 3 received significant attention as a promising photoanode due to its band gap (∼2.1 eV), good stability, low cost, and natural occurrence. α-Fe 2 O 3 thin films were prepare...

Ausführliche Beschreibung

Gespeichert in:
Bibliographische Detailangaben
Veröffentlicht in:Journal of materials research 2016-06, Vol.31 (11), p.1580-1587
Hauptverfasser: Maabong, Kelebogile, Hu, Yelin, Braun, Artur, Machatine, Augusto G.J., Diale, Mmantsae
Format: Artikel
Sprache:eng
Online-Zugang:Volltext
Tags: Tag hinzufügen
Keine Tags, Fügen Sie den ersten Tag hinzu!
Beschreibung
Zusammenfassung:In searching for a suitable semiconductor material for hydrogen production via photoelectrochemical water splitting, α-Fe 2 O 3 received significant attention as a promising photoanode due to its band gap (∼2.1 eV), good stability, low cost, and natural occurrence. α-Fe 2 O 3 thin films were prepared by economic and facile dip coating method and subsequently subjected to an anodic potential of 700 mV versus Ag/AgCl in 1M KOH for different anodization times (1, 10, and 900 min) under illumination. X-ray diffractometry revealed increase in crystallites size from ∼31 nm for nanoparticles in pristine state to ∼38 and 44 nm after anodization for 1 and 900 min, respectively. A clear positive correlation between anodization time and grain (particle) size was observed from field emission gun scanning electron microscopy and atomic force microscopy (AFM); longer exposure time to anodizing conditions resulted in larger grains. Grain size increased from ∼57.9 nm in pristine state to ∼153.5 nm after anodization for 900 min. A significant smoothening of the surface with increase in anodization time was evident from AFM analysis.
ISSN:0884-2914
2044-5326
DOI:10.1557/jmr.2016.53