Fuel cell stack design and modelling with a double-stage boost converter coupled to a single-phase inverter

Abstract A comprehensive proton-exchange membrane fuel cell stack model was developed and integrated with a two-stage DC/DC boost converter. It was directly coupled to a single-phase (two levels—four pulses) inverter without a transformer. The pulse-width modulation signal was used to independently regulate every converter phase. The converter was modelled using a MATLAB®/Simulink® environment and an appropriate voltage control method. The analysis features of the suggested circuit were created and, through established experiments, the simulation results were verified. A single-phase (two levels—four pulses) inverter control circuit was tested and it produced a pure sinusoidal waveform with voltage control. It matches the voltage of the network in terms of amplitude and frequency. A sinusoidal pulse-width modulation approach was performed using a single-phase (two levels—four pulses) pulse-width modulation inverter. The results demonstrated an enhancement in the standard of the output wave and tuned the dead time with a reduction of 63 µs compared with 180 µs in conventional techniques. A comprehensive model of a proton-exchange membrane fuel cell stack is integrated with a single-phase (two levels—four pulses) inverter without a transformer. Pulse-width modulation is used to independently regulate every converter phase. As a result, the dead time is reduced compared to conventional techniques. Graphical Abstract Graphical Abstract