Simulating increased Lamb wave detection sensitivity of surface bonded fiber Bragg grating

Fiber Bragg grating (FBG) sensors are excellent transducers for collecting ultrasonic wave signals for structural health monitoring (SHM). Typically, FBG sensors are directly bonded to the surface of a structure to detect signals. Unfortunately, demodulating relevant information from the collected signal demands a high signal-to-noise ratio because the structural ultrasonic waves have low amplitudes. Our previous experimental work demonstrated that the optical fiber could be bonded at a distance away from the FBG location, referred to here as remote bonding. This remote bonding technique increased the output signal amplitude compared to the direct bonding case, however the mechanism causing the increase was not explored. In this work, we simulate the previous experimental work through transient analysis based on the finite element method, and the output FBG response is calculated through the transfer matrix method. The model is first constructed without an adhesive to assume an ideal bonding condition, investigating the difference in excitation signal coherence along the FBG length between the two bonding configurations. A second model is constructed with an adhesive to investigate the effect of the presence of the adhesive around the FBG. The results demonstrate that the amplitude increase is originated not from the excitation signal coherence, but from the shear lag effect which causes immature signal amplitude development in the direct bonding case compared to the remote bonding case. The results also indicate that depending on the adhesive properties the surface-bonded optical fiber manifests varying resonant frequency, therefore resulting in a peak amplitude response when the input excitation frequency is matched. This work provides beneficial reference for selecting adhesive and calibrating sensing system for maximum ultrasonic detection sensitivity using the FBG sensor.