Modeling of a xenon short arc lamp considering the behavior of tungsten vapour evaporated from electrodes

The tungsten vapour produced from the electrodes during short arc lamp operation is transported by gas convection and then deposited on the inner quartz bulb wall to form a tungsten thin film, causing the wall to blacken. We have been able to consider important phenomena for the first time by developing a unified numerical simulation model incorporating relevant sub-models. These include the absorption of the radiant energy due to blackening of the lamp and the temporal variation in the lamp parameters. The validity of the numerical simulation model is first evaluated by comparison with experimental results. The basic characteristics of the lamp obtained using the model is found to be in good agreement with the experimental results and other research results. The influence of the bulb wall blackening is then examined. The temperature of the bulb is shown strongly affected by convective heat transfer from the hot gas, and the temperature rise of the bulb after blackening is found to be primarily governed by the absorption of the radiant energy by the tungsten thin film. Through the increase in the bulb temperature, the gas temperature in the bulb is also increased. This raises the operating pressure, which increases the stress on the bulb wall. Consequently, it is demonstrated that the probability of breakage gradually increases with time due to the blackening by tungsten vapour deposition.