Reliability analysis of consolidation settlement in clay subsoil using FOSM and Monte Carlo simulation

•Errors in FOSM, when applied to consolidation settlement of clay, are quantified.•Both theoretical scenarios and real case studies are considered.•Errors are acceptable in reliability analysis of normally consolidated clays.•Larger errors are introduced if applied to overconsolidated clays.•Errors...

Ausführliche Beschreibung

Gespeichert in:
Bibliographische Detailangaben
Veröffentlicht in:Transportation Geotechnics 2021-09, Vol.30, p.100625, Article 100625
Hauptverfasser: Löfman, Monica Susanne, Korkiala-Tanttu, Leena Katariina
Format: Artikel
Sprache:eng
Schlagworte:
Online-Zugang:Volltext
Tags: Tag hinzufügen
Keine Tags, Fügen Sie den ersten Tag hinzu!
Beschreibung
Zusammenfassung:•Errors in FOSM, when applied to consolidation settlement of clay, are quantified.•Both theoretical scenarios and real case studies are considered.•Errors are acceptable in reliability analysis of normally consolidated clays.•Larger errors are introduced if applied to overconsolidated clays.•Errors in multi-layer cases are relatively lower than in single layer problems. The settlement of ground-supported transportation infrastructures may vary greatly depending on the uncertainties related to compressibility properties and overconsolidation of clay. These uncertainties can be considered systematically by means of reliability analysis where the probability distribution of consolidation settlement is evaluated. Hence, this paper applies two well-known reliability methods, first-order second-moment method (FOSM) and Monte Carlo simulation, to various theoretical consolidation scenarios and three case studies of test embankments founded on normally consolidated (NC) or overconsolidated (OC) clay subsoil. The aim is to assess the accuracy and limitations of FOSM when applied to estimate the mean, the standard deviation, or the upper 95th percentile of the settlement. According to the results, the accuracy of FOSM is adequate for most serviceability limit state (SLS) purposes if the clay is normally consolidated. On the other hand, large relative errors may be introduced for OC clays where the relative contribution of OC and NC strains creates a strongly non-linear problem. It is concluded that FOSM, combined with second-order mean, may be applied to preliminary settlement estimation of OC clays. However, in the actual SLS verification with certain target reliability, Monte Carlo simulation should be used to ensure high enough accuracy.
ISSN:2214-3912
2214-3912
DOI:10.1016/j.trgeo.2021.100625