New insights on bonding mechanism of FCC and BCC high entropy alloy microparticles upon supersonic impact using micromechanical adhesion test

Coating buildup in cold spraying (CS) relies on particle bonding upon impact, thus making it a significant area of study. High entropy alloys (HEAs) are a class of materials with superior work-hardening ability and resistance to softening, making their particle impact and bonding particularly important to understand for their cold sprayability. In this study, the splat adhesion strength is measured with a scratch test for FCC CoCrFeMnNi and BCC AlCrFeMnNi HEA microparticles deposited on mirror-polished SS304 substrates. Nanoindentation tests were conducted to estimate the tensile and shear strengths of the HEA powders. The results showed that particle deformation and jetting were dominant in the FCC HEA/SS304 system, while substrate deformation was dominant in the BCC HEA/SS304 system. Focused ion beam cross sections of particles confirmed that the FCC HEA had good bonding and underwent significant deformation and grain refinement at the substrate/particle interface, while the BCC HEA had limited bonding only in the sheared zone of the particles. In spite of the very limited deformation of BCC splats, their average adhesion strength was measured to be 451 ± 141 MPa, which is significantly higher than that of FCC splats, with an average value of 308.7 ± 69.3 MPa. Fracture surface analysis revealed that FCC splats consistently exhibit ductile fracture, regardless of whether it occurs at the particle, substrate, or interface. In contrast, for BCC splats, fracture was ductile when occurring at the interface and substrate sides, while it was cleavage when occurring on the particle side. These findings suggest that the toughness and shear strength of the bonding developed at the interface were higher than those of the particle. It was found that the flattening ratio (FR) of the particles decreases for both FCC and BCC HEA splats with an increase in particle size, resulting in a decrease in adhesion strength. Metallurgical bonding has been identified as the primary factor contributing to the adhesion strength of both FCC and BCC HEA splats. Particle penetration, indicative of mechanical interlocking, appears to have little or no effect on adhesion strength. However, it does positively influence the increase in adhesion energy of the splats. [Display omitted] •Distinct deformation & bonding of FCC & BCC HEA microparticles under supersonic impact•Micromechanical adhesion strength of BCC HEA microparticles are higher than FCCs.•Developed bonding in BCC HEA/SS304 sub