Tailoring surface properties of Poly(caprolactone)/Hydroxyapatite scaffolds through aminolysis and multi-walled carbon nanotube coating for bone tissue engineering

In this study, the effects of surface modification on the physicochemical properties, degradation behavior, and cellular responses of poly(caprolactone) (PCL)/hydroxyapatite (HAp) scaffolds using carboxylated multi-walled carbon nanotubes (MWCNTs) were investigated. The scaffolds were prepared using the fused deposition modeling (FDM) technique, followed by aminolysis for 15, 30, and 60 minutes. Subsequently, the scaffolds were immersed in MWCNT solutions with concentrations of 0.1 %, 0.5 %, and 1 % g/mL to achieve the desired coating. Various characterization techniques were employed to evaluate the surface morphology, chemical composition, and structural changes induced by the coating. FESEM images revealed a uniform MWCNT coating on the PCL/HAp scaffolds at an optimal concentration of 0.5 % g/mL, while lower concentrations resulted in incomplete coating and higher concentrations led to MWCNT agglomerations. The MWCNT coating successfully enhanced the conductivity of the scaffolds, with electrical conductivity increasing from near zero for the non-coated PCL/HAp scaffolds to 5 × 10−5 S/m for the MWCNT-coated scaffolds. Additionally, the coating exhibited improved wettability, as demonstrated by decreased water contact angles from 67.71° for non-coated surfaces to 51.50° for the MWCNT-coated surfaces. Furthermore, the in vitro degradation studies showed that HAp in the PCL matrix accelerated the hydrolysis rate, resulting in higher degradation rates for the PCL/HAp scaffolds than pure PCL scaffolds. The MWCNT coating further influenced the degradation behavior, with variations in degradation rates depending on the MWCNT concentration. Cell viability assays using MG-63 cells revealed improved cell viability and adhesion on the MWCNT-coated PCL/HAp scaffolds compared to plain PCL and PCL/HAp scaffolds. The cell viability increased from 84 % for plain PCL and 103 % for PCL/HAp to 109 % for the MWCNT-coated scaffolds. Moreover, FESEM images showed increased cell adhesion on the MWCNT-coated surfaces, with optimal adhesion observed on the scaffolds coated with 0.5 % g/mL MWCNTs. The results of this study highlight the potential of MWCNT coatings to improve the surface properties of PCL/HAp scaffolds, making them excellent choices for bone tissue engineering applications. [Display omitted] •PCL/HAp scaffolds functionalized with amine groups via aminolysis and MWCNTs.•MWCNT coating shows higher stability on aminolyzed than non-aminolyzed surfaces.•At 0.5 % g/mL,