Effect of Sc/Zr ratio on superplastic behavior of ultrafine-grained Al–6%Mg alloys

Al–6%Mg-Sc-Zr alloys with a combined Sc and Zr ratio of 0.32 wt% make up the focus of this research. The content of Sc and Zr varied with an increment of 0.02%. Their ultrafine-grained (UFG) microstructure was formed with Equal Channel Angular Pressing (ECAP). Superplasticity tests were performed at temperatures ranging from 300 to 500 °C and at a strain rate varying between 3.3·10−3 and 3.3·10−1 s−1. The values of strain hardening factor (n), strain rate sensitivity factor (m), and superplastic deformation threshold stress (σp) were determined. The microstructure and failure patterns of the alloys post superplasticity tests were studied. The effect of the Sc/Zr ratio on the superplastic behavior, cavitation fracture and dynamic grain growth of UFG Al–6%Mg alloys was investigated. The satisfiability of Hart's criterion for calculating uniform deformation value under superplastic conditions was verified. Grain boundary sliding and intragranular deformation make comparable contributions to superplastic flow in the UFG aluminum alloys under study. Al–6%Mg-0.20%Sc-0.12%Zr (Sc/Zr = 3.3 at.%) and Al–6%Mg-0.18%Sc-0.14%Zr (Sc/Zr = 2.8 at.%) alloys exhibit the highest superplasticity. Shown that changes in the Sc/Zr ratio affect the precipitating mechanism, spatial distribution and composition of the precipitating particles Al3(ScxZr1-x). The optimal Sc/Zr ∼2.6–3.3 (at.%) ratio for the Al–6%Mg alloy corresponds to an Al3(Sc0.5Zr0.5) and Al3Sc precipitated particles. The large Al3Zr particles formed through the discontinuous precipitation mechanism was detected at Sc/Zr