Modelling of the intergranular fracture of TWIP steels working at high temperature by using CZM–CPFE method

•A CZM–CPFE method considering the temperature effect to reveal the intergranular cracking was developed and validated by in–situ SEM.•The CZM-CPFE describes the mechanical response of grain interiors and the damage and failure of GBs.•LAGBs of TWIP steels delay intergranular fracture, while the GBs at 40°–70° are most easily damaged.•UTS and failure strain of TWIP steels are increased with the decreasing grain size.•The intersection between the GBs and the larger size microvoids facilitates microcrack initiation and intergranular cracking. Grain boundaries (GBs) of metallic materials will become the weakest and most vulnerable place when the materials deform at high temperature. This could directly affect deformation flow, plastic strengthening, the initiation and propagation of microcracks, and finally the fracture failure of materials. In this research, to reveal the high temperature deformation mechanisms of twinning–induced plasticity (TWIP) steels, the crystal plasticity finite element method (CPFEM) was employed to model the mechanical response of grain interiors. The cohesive zone model (CZM) of the bi–linear traction separation law (TSL) was developed to describe the damage and failure of GBs. By combining CZM and CPFEM, an analysis method was proposed to investigate the effect of the microstructure morphology, orientation and size of grains, and temperature. Furthermore, the damage initiation, accumulation and fracture at GBs were represented by the representative volume element model based on the CZM–CPFE method to explore the influences of GB angle, grain size and local microvoids (including the location and size) on the GB cracking. The stress damage cloud maps, the distribution of quadratic stress damage initiation criterion (QUADSCRT) and the scalar stiffness degradation (SDEG) describing the damage and fracture along the GBs were used to articulate the relationships of GB angle, size effect, local microvoids and the expected failure strain. The results show that low angle grain boundaries (LAGBs), the small average grain size (