Gas and powder flow characteristics of packed bed: A two-way coupled CFD-DEM study

•Gas and powder flow characteristics of packed bed used for nuclear reactors were investigated.•A two-way coupled CFD-DEM model was built and in-time data exchange was achieved.•Eight different shapes of powders were inserted into the packed bed to study the effect of shape.•For the influence of powder shape, a cut-off sphericity value equal to 0.96 was observed.•The flowability was demonstrated to be affected by multiple mechanisms. A two-way coupled Computational Fluid Dynamics (CFD) and Discrete Element Method (DEM) calculation was performed to numerically investigate the gas and powder flow characteristics within a packed bed. The analysis and discussion focused on the effects of gas phase velocity, particle shape, and size on the flow behavior of the powders. The results revealed that the average absolute velocity of the powder increased with an increase in the inlet gas flow rate. Conversely, the average dimensionless velocity exhibited the opposite trend. Particle shape significantly impacted the flowability of the powders. A critical value of sphericity equal to 0.96 was observed. For powders with sphericity less than 0.96, the average velocity fluctuated around a progressively decreasing value over time, and the powders tended to accumulate in the inlet region. In contrast, powders with a sphericity greater than 0.96 exhibited average velocities fluctuating around a constant value throughout the simulation. Additionally, a smaller number of these particles remained within the fluid domain, indicating a higher flow rate through the packed bed and ultimately exiting the fluid domain. Regarding the influence of particle size, the flowability reached a minimum value at a radius of 0.14 mm, with the average powder velocity mirroring this trend. Powders with a radius exceeding 0.14 mm demonstrated increasing flowability and average velocity. The observed impact on flowability was likely due to a combination of mechanisms. The findings presented in this paper offer valuable insights into the dynamics of powders within a packed bed. This knowledge can be instrumental in the design and analysis of packed bed reactors. [Display omitted]