Neutronics analysis for conceptual design of target system based on a deuteron accelerator-driven fusion neutron source

A Breeding Blanket (BB), producing tritium and heat energy converted to electricity, is a critical component for the successful Fusion Demonstration Reactor (DEMO). A dedicated neutron source is required to validate the performance of the DEMO BB in a continuous long-term fusion-like environment. Therefore, a pre-conceptual design study has been carried out for the Integrated Breeding Test Facility (IBTF) to evaluate the DEMO BB performance. The IBTF is based on a 40 MeV deuteron accelerator-driven system with a maximum current of 10 mA. A solid Beryllium (Be) target with a 20 cm width and height is used to irradiate the tritium breeding unit (TBU). This study conducted a neutronics analysis of the Be target system of the IBTF. The produced neutron energy spectrum and yield were evaluated on a beam energy of 30 to 50 MeV. The analysis results show that the forward direction neutron yield with the 40 MeV deuteron is the highest at 4.92E + 15 n/s, and the neutron ratio of 10–20 MeV is also the highest. A Blistering Mitigation Layer (BML) was added to prevent the blistering effect caused by the deuteron beam within the Be target. A comparison was done for the performance evaluation of the BML candidates vanadium, palladium, tantalum, and niobium. There were no significant differences in the forward direction neutron yield for the BML options. Vanadium was the most beneficial based on the activation analysis results. Therefore, vanadium with a 0.3 mm thickness was added behind the Be target with a 5 mm thickness. In addition, neutronics analysis was conducted for the test cell shielding designs. Concrete 3.5 m thick was required to satisfy a dose of less than 100 uSv/h during the beam operation. When evaluating the dose rate during maintenance, a dose along the cooling pipes was observed due to the activation of the pipes. The neutron flux with the cooling pipes was reduced by using B4C in the maintenance cell shielding, the dose rate was below 100 uSv/h in the test cell. Deuteron and neutron transport calculations were carried out using MCNP6 with the TENDL2019 cross-section library. Activity analysis and gamma source production were performed using FISPACT-Ⅱ with the TENDL2017 cross-section library.