A new phenomenological anisotropic tensile failure criterion and its application in FDEM simulations

•A new phenomenological tensile failure criterion with an anisotropic coefficient was proposed.•Direct tensile test of the Kangding slate was carried out to verify the accuracy of the new criterion.•The tensile strength data of eight typical layered rocks were collected and compared with the other six typical tensile strength criteria to verify the universality and superiority of the new criterion.•Based on the sensitivity analysis of tensile rate, the loading rate of 0.01 m/s was recommended for the samples with various foliation angles.•Layer thickness has little effect on tensile strength, but a significant effect on tensile failure modes. The tensile strength is a key parameter for the design of many geotechnical engineerings such as tunnel support, slope support, and petroleum drilling. The tensile strength in layered rocks, however, is anisotropic due to the existence of bedding planes. In this paper, to study the anisotropic tensile behaviors, a series of direct tensile tests were conducted using Kangding slate with five different foliation angles (β = 0°, 30°, 45°, 60°, and 90°). Based on the N-Z criterion, a new tensile failure criterion with the anisotropic coefficient was proposed. The tensile strength data of nine typical layered rocks were collected to evaluate the prediction ability of seven anisotropic tensile failure criteria including the new criterion. Embedding the new criterion into FDEM, the loading rate-dependent and layer thickness-dependent tensile mechanism of layered rock under direct tensile test were simulated. The experimental and numerical simulation results showed that the foliation angle significantly affected the tensile strength and failure modes of the slate. With the increase of foliation angle (β), the tensile strength of nine typical layered rocks, including Kangding slate, presented a non-linear increase trend. Compared with the other six typical anisotropic tensile failure criteria, the new criterion has the best prediction capability on the tensile strength of rocks with four different anisotropic degrees, and therefore the new criterion was recommended. The new criterion was embedded in FDEM to carry out direct tensile simulation of slate with different β. The numerical simulation results were in good agreement with the experimental results, further verifying the accuracy of the new criterion. The loading rate sensitivity analysis indicated that a tensile rate of 0.01 m/s was recommended to assure quasi-static load