Ceramics from Municipal Waste Incinerator Bottom Ash and Wasted Clay for Sensible Heat Storage at High Temperature

Although work has been done to understand the sintering behavior and properties of Municipal Waste Incinerator Bottom Ashes to produce sintered (Bethanis et al. in Ceram Int 28:881–886, 2002; Cheeseman et al. in Resour Conserv Recycl 43:147–162, 2005; Bourtsalas et al. in Waste Manag 45:217–225, 2014; Taurino et al. in J Eur. Ceram Soc 37:323–331, 2017) or sinter-crystallized (Schabbach et al. in J Non Cryst Solids 357:10–17, 2011; Barbieri et al. in J Non Cryst Solids 354:521–528, 2008) ceramics, most of the trials reported in the literature focuses on the use of extensively milled bottom ashes powders (particle size around 1–50 µm), using processes that might not be easily transferable to industrial production at reasonable cost, and producing small cylinders with uniaxial compression technique on powders. This paper summarizes the development process of an extruded ceramic material made of gross-milled bottom ashes and waste clay, designed to be easily mass-produced using production capacities available in the building bricks industry, to be used as a high-temperature thermal energy storage material, which represents an alternative to the petrurgic ceramic previously developed for this application (Py et al. in J Sol Energy Eng 133:031008, 2011; Kere et al. in Int Conf Eng Waste Biomass Valoris, Porto, 2012; Py et al. in Stockage de l’ énergie: énergie thermique, stockage thermique haute température). Post-treated incinerator bottom ashes from a commercial incinerator has been collected, characterized and processed to form ceramic materials, using clay as a binder. Ashes were milled, dried, and mixed with various amounts of an illitic clay (produced as washing mud by a quartz quarry) prior to extrusion (cylindrical pellet) and firing at different temperatures, ranging from 1100 to 1120 °C. The sintered samples have been characterized in terms of density, mechanical strength, thermal capacity and thermal conductivity. Their mineral structure has also been studied. This work follows a study on the feasibility about the production of MWIBA based slabs with uniaxial compaction, and can be seen as an improvement regarding the shaping of the green bodies, more compatible with thermocline thermal energy storage process. The resulting sintered ceramics exhibit interesting properties such as relatively high mechanical resistance and low thermal conductivity, along with moderate density. These properties allow envisioning the use as filler material for thermoclin