Determination of fracture toughness from the extra penetration produced by indentation-induced pop-in

The fracture toughness of small volumes of brittle materials may be investigated by using pyramidal indenters to initiate radial cracks. The length of these cracks, together with indenting load and the hardness to modulus ratio of the material, were combined to calculate the critical stress intensit...

Ausführliche Beschreibung

Gespeichert in:
Bibliographische Detailangaben
Veröffentlicht in:Journal of materials research 2003-06, Vol.18 (6), p.1412-1419
Hauptverfasser: Field, J. S., Swain, M. V., Dukino, R. D.
Format: Artikel
Sprache:eng
Online-Zugang:Volltext
Tags: Tag hinzufügen
Keine Tags, Fügen Sie den ersten Tag hinzu!
Beschreibung
Zusammenfassung:The fracture toughness of small volumes of brittle materials may be investigated by using pyramidal indenters to initiate radial cracks. The length of these cracks, together with indenting load and the hardness to modulus ratio of the material, were combined to calculate the critical stress intensity factor Kc pertinent to fracture toughness. Modulus and hardness may be obtained from the literature or may be measured using nanoindentation techniques. If the material volume is very small, such as single grains in a conglomerate, a reduction of scale may be obtained by reducing the internal face angles of the indenter. This encourages crack initiation at lower loads, but cracks produced at very low loads are short and difficult to measure. Experiments on fused silica and glassy carbon suggested that radial cracks are initiated during loading and that when indenters with sufficiently small angles are used these cracks immediately pop-in, to become fully developed median/radial crack systems. Following pop-in, the rate of penetration of the indenter increases and at higher loads there is an extra increment of penetration over that which would otherwise have occurred. In this study a method is described whereby this extra penetration may be determined. Then for two dissimilar brittle materials, crack length is shown to be correlated with extra penetration leading to a relationship that may possibly avoid the necessity for crack-length measurement.
ISSN:0884-2914
2044-5326
DOI:10.1557/JMR.2003.0194