Electrolyte Flow Field Variation: A Cell for Testing and Optimization of Membrane Electrode Assembly for Vanadium Redox Flow Batteries

A great deal of research has been dedicated to improving the performance of vanadium redox flow battery (VRFB). In this work, we propose the design of a cell for testing membrane electrode assembly of VRFB, which enables the optimization of the flow field, conditions of charge‐discharge tests, and the nature of components (electrodes, membrane) with minimal time and material expenses. The essence of the proposed cell is that the system of channels distributing the electrolyte is made by cutting shaped holes in the sheets of graphite foil (GF). This manner allows easy modification of the flow field configurations. Polarization curves for serpentine, interdigitated, and flow‐through systems were measured according to procedures used in such studies. Cell with GF plates being tested with vanadium‐sulfuric acid electrolyte, outperforms the cell with conventional graphite plates with the same parameters of the flow field. It demonstrates 734 mW cm−2 of peak power density at SOC 50 and 84.3 % of energy efficiency at 84.5 % of electrolyte utilization under galvanostatic charge/discharge cycling with 75 mA cm−2. Electrolyte flow field variation: A cell was developed, where the system of channels distributing the electrolyte are made from sheets of graphite foil (GF), and that allows to easily vary the flow field configuration. The cell tested on vanadium‐sulfuric acid electrolyte with GF outperforms the cell with conventional graphite plates with the same parameters of the flow field. It demonstrates 734 mW cm−2 of peak power density at SOC 50 and 84.3 % of energy efficiency at 84.5 % of electrolyte utilization under galvanostatic charge/discharge cycling with 75 mA cm−2.