Assessment of Design Consistency for Two-Lane Rural Highways with Low Tortuosity Alignment

One technique employed to enhance road safety involves assessing the alignment’s consistency. A prevalent measure of consistency is evaluating speed variations along the alignment. A key consideration in this assessment is determining the speed upon which the road alignment should be based. This research reveals that on two-lane rural highways with low tortuosity alignments, operating speeds on horizontal curves and tangents consistently exceeded not only the design speeds but also the maximum permissible design speed for the road category. Consequently, using the design speed to assess consistency on these roads is deemed impractical, and utilizing operating speed poses challenges due to speeds exceeding the maximum permissible limit. The objectives of this paper are twofold: to explore the relationship between design consistency and safety levels on two-lane rural highways with low tortuosity alignments (which have been insufficiently covered in research) and to propose speed-control measures to limit the maximum operating speed to the maximum permissible speed. The study findings suggest that on roads with a low tortuosity alignment, operating speeds depend much more on the general characteristics of the alignment (evaluated in the operating speed models through the desired speed). Further, assessing speed consistency is feasible only with a rigorous control of the maximum operating speed (desired speed). Additionally, a specific type of speed control is recommended, achieved by limiting the curvature change rate (CCR) of the road section based on the desired speed (environmental speed), whose evaluation becomes a crucial factor.