Determination of the critical state of a silty sand iron tailings in triaxial extension tests using photographic correction

Determination of the critical state of tailings is essential to the stability analysis of tailings dams, especially to assess the susceptibility to flow liquefaction failures. In contrast to the peak resistance, which can be determined in triaxial tests at relatively small strains, the critical state is often reached at higher strains. Therefore, determining the critical state in triaxial extension tests is more difficult than in compression tests because the concentration of stresses and strains in extension tests is more severe and usually inevitable, resulting in necking that may greatly affect the computed deviatoric stress and void ratio (if the test is drained). This paper presents a simple and cost-effective method of necking correction using photography. The method was used in the determination of the critical state in drained triaxial extension tests. A sample of silty sand tailings obtained from the reservoir of the Fundao dam two years prior to its collapse was used. The critical state friction angle was approximately the same in compression and extension, showing that the proposed method is promising as many authors consider that the critical state friction angle is the same in these two conditions.