Measurement modes of the response time of a magneto-rheological fluid (MRF) for changing magnetic flux density

The response of a magneto-rheological fluid (MRF) to a change of magnetic flux density is investigated by using a commercial plate–plate magneto-rheometer MCR501 (Anton Paar GmbH) at constant shear rate. The instrument was modified to allow an online determination of the transient flux density in the MRF. Both current and voltage imposition to the magneto-cell were applied by using a power operational amplifier to drive the electromagnet. Assuming a Maxwell behavior with switching time λ and a linear increase in shear stress with flux density, analytic relations for the transient shear stress are derived for sinusoidal and single exponential flux densities vs time. True switching times of a few milliseconds are only obtained if the low pass filter in the original MCR501 torque signal is surpassed by a firmware allowing a sampling rate of 0.1 ms. For a sinusoidal flux density, the switching time is derived from the modulation depth of the shear stress. An upper bound of λ