Plastic deformation of commercially-pure titanium: experiments and modeling

The plastic behavior of commercially-pure titanium (CP-Ti) is assessed using a combination of experiments and analysis. A total of 23 (with three repetitions each) experiments were performed on a hot-rolled CP-Ti plate of 12.7 mm thickness. The experiments performed are uniaxial tension and uniaxial compression in-plane at 15° angles to the rolling direction (RD), and in the normal direction (ND), as well as plane-strain tension (PST) at 15° angles to the RD of the plate. The uniaxial tension and compression tests involve standard specimen geometries, except for the one in the ND, which required the creation of a custom, miniature tensile specimen. The PST specimen is a custom geometry to impose a constraint in the transverse direction, giving rise to the plane-strain condition. A procedure using finite element analysis is described to determine the axial stress in a PST test. The experiments reveal the deformation-induced anisotropy and tension-compression asymmetry of CP-Ti. The material strength is found to increase going from RD to transverse direction (TD) to ND. The experiments are then used to calibrate four constitutive models of increasing complexity: von Mises, Hill '48, KYL '12 and CPB '06. The calibrated models along with the experimental information are shown using three alternative approaches: biaxial tension-compression plane, Haigh-Westergaard or π-plane, and the one recently introduced by (Korkolis et al., 2017) that allows representation of stress states where the full stress tensor is active. Furthermore, the test results from off-axis experiments, not used in the calibration, are used to examine the performance of each model. The best performance in predicting the experiments was exhibited by the KYL '12 and CPB '06 models. It is expected that this improved understanding and representation of the plastic behavior of CP-Ti can lead to improved material models and numerical simulations of manufacturing and service. •Mechanical tests are performed on CP-Ti at multiple angles to the material axes.•The material strength increases going from RD to TD to ND.•Some compression orientations exhibit transition from twinning to slip.•The von Mises, Hill 1948, KYL ′12 and CPB ′06 models are calibrated.•The 4 model predictions are compared with the experiments.