Distortions in Electrochemical Impedance Spectroscopy Measurements Using 3-Electrode Methods in SOFC. I - Effect of Cell Geometry

The use of a reference electrode (RE) is necessary to independently measure the overpotential of each electrode in solid oxide fuel cells (SOFC). This type of set‐up, known as the 3‐electrode (or 3‐terminal) configuration, can give erroneous results if the RE does not effectively separate the potential of the two active electrodes. In this work, calculations and experiments were performed to verify the effectiveness of the 3‐electrode configuration used in electrochemical impedance spectroscopy (EIS) measurements for studying the kinetics of anodes and cathodes in SOFC. Initially, a theoretical analysis of the impedance distortions in relation to the electrode geometry and configuration is presented and the main causes of distortions are elucidated. Then, this analysis is corroborated by experimental results obtained using two specially designed cells. Calculations and experiments reconfirm that configurations characterised by electrodes of equal area and symmetrical placement do not produce EIS distortions when the electrodes have similar area‐specific polarisation resistances and time constants. Moreover, distortions can be low even in considerably misaligned configurations when electrodes are small and relatively inactive.